A complete kit that includes the Monster MM3 mill and hopper, with or
without the extension. Monster mills are known for being great quality,
top of the line, homebrewing mills. With all the great features of the
already popular MM-2, and the addition of a third roller, you'll be able
to achieve the best crush around, at a higher throughput speed.
MM-3 crushes all your grain twice, with one pass through the mill. It
starts with a preliminary crush through the initial fixed gap between
the top two rollers, and then ends with a pass through the second gap
between the drive roller, and the bottom third roller. The initial pass
slightly flattens the grain, and gets it ready for the next crush, that
breaks apart the grains and loosens the starch with minimal husk damage.
The MM-3 consists of a 6061 aluminum block frame with three 6" long
steel rollers riding on SAE 841 oil impregnated bronze bushings. We use a
superior grade of steel that is much harder than what is found on most
comparable products and should last almost twice as long. The drive
shaft, and all the axles are integral to the roller rather than screwed
into the ends. This makes it fine to drive the mill clockwise, or
counter-clockwise. All the axles are 3/8", with minimal freeplay in the
One knurled steel roller is driven by a standard electric drill (not
included) to feed the grain through the initial fixed gap of
approximately .060", and then through the adjustable secondary gap and
crush the grist. Both ends of the non-driven top idler roller ride in
bronze bushings that are pressed into the frames, while the second idler
roller rides in bushings that are offset mounted in an adjustable knob.
The knob is held in a fixed position by a set-screw that you can loosen
to adjust the mill. This system provides an adjustment range of .065".
The knobs are made from 303 stainless steel for excellent durability,
and are larger in diameter than the competition, as well as knurled for a
positive grip. They've also added a groove in our newest design knobs
with a matching rounded head on the thumbscrew that allows for a much
better grip on the knob to avoid gap changes while milling, and also
providing knob retention.
These Packages come complete with a Base, 3 Roller Monster Mill Body,
and a Hopper. Choose whether to include the Hopper Extension, which
upgrades Hopper capacity to a huge 39 lb!
- Three six-inch steel rollers form two gaps, a preliminary fixed gap of approx .060", and a fully adjustable secondary gap.
- Dual eccentric adjusters: 0 to .065" secondary gap - built from STAINLESS STEEL for no galling
- 8 lbs / minute throughput
- 3 x 6" hardened steel rollers
- Rollers last for 12,000 - 15,000 lbs of grain
- Drill-drive - CW, OR CCW
- Alloy frame
- SAE 841 oil impregnated bronze bushings
- 1.5" diameter steel rollers
- 3/8" integral drive shaft w/3 flats for drill driving, 2" long outside frame
- 1144 alloy steel rollers