The MiniMash Lauter Tun is designed from the ground up for brewers. It is not a converted water jug or picnic cooler.
The MiniMash Lauter Tun is a round, 15 gallon tank will hold up to 35 lbs of grain. Tank is 21 3/4" tall by 15" in diameter. 3/32" screen holes are ideal for a good filter bed. 5/16" thick walls provide mass for strength and good insulation. Transfers BTUs 100,000 times slower than stainless steel based on BTU transfer rate high-density polyethylene (HDPE). Sometimes a blanket or neoprene for insulation is needed.
False Bottom:
The true bottom is 12 1/4” diameter and 1 3/4” deep. The size difference from the tank above forms a ledge inside. A stainless steel bolt is threaded through a center leg with a wing nut and washer to seal the screen in place tight against this ledge and the leg. The flat screen is great for lautering. It will not sag or allow grain to pass into the true bottom. The top of the bolt is an ideal depth measurement for stirring. Now it is easy to stir the grain without disturbing the filter bed.
Sparge Head:
The brass sparge head has no moving parts. The design spreads the hot liquor evenly. However, it does require some water drop or pressure to reach the sides of the tank. Hobby Beverage recommends leaving about 1/2” of water on top of the grain bed and stirring regularly. The hot liquor will sprinkle gently onto the grain. The sparge head screws into the 1/2” threads in the lid and will not clog.
Sparge Arm:
The sparge arm is sold separately. The center polyethylene post is held in place with a stainless steel spring clip on a PVC fitting separated for easy rotations with a Delrin washer. The force of the water (24 inch drop) pushing out the holes rotates the arm.
Accurate Temperature Monitoring:
Thermometer threads are strategically located for easy and accurate monitoring just above the screen and below the level of the center screen hold down bolt.
Thermometer is sold separately.
Sight Glass:
This design perfection is to assist in balancing the vacuum created when hot liquor flows out. The sight glass will also prevent channeling. When you know the liquid level you will know how recirculating (RIMs) is progressing or when to add hot liquor. With the MiniMash, the variables of mashing are under your control.
Extra Threads:
Two extra 1/2" threads have been added to the back of the MiniMash. One at the top and one at the bottom below the screen for RIMs or any other creative ideas you may have. The top thread allows you to bypass the sparge head directly into the top of the grain bed. The extra lower thread can be used for specific gravity and pH testing.
Recipe Size:
Designed for both 5 and 10 gallon recipe size brewers.
Ships Ready to Mash. Just clean, warm, start your mash - sparge when ready - enjoy the new flavors and challenge.
Click here for Use & Care instructions.
This item is shipped from the manufacturer. Please allow 12-15 business days for shipping.
